LOL, rodger that 
Fark, I just fucked my new Sony 40"
The LCD panel hangs from ribbon cables at the top, and is loose at the base allowing it to tilt forward off the backlight pane underneath easily.
An outer tin frame holds the lot in place.
When putting the outer tin frame back on I forget to check the LCD panel was sitting down flush.
Long story short. the bottom edges on both side were sitting 2mm over the lower rests.
When I tightened up the tin frame, the two bottom corner cracked.
I fixed the original problem no worries but now the cracked corners have spread across the bottom 1/6th part.
Bloody Nora, I wasn't even pissed!
Ow well, live and learn.
Dire Straights on the small screen again tonight then.
Fark, I just fucked my new Sony 40"
The LCD panel hangs from ribbon cables at the top, and is loose at the base allowing it to tilt forward off the backlight pane underneath easily.
An outer tin frame holds the lot in place.
When putting the outer tin frame back on I forget to check the LCD panel was sitting down flush.
Long story short. the bottom edges on both side were sitting 2mm over the lower rests.
When I tightened up the tin frame, the two bottom corner cracked.
I fixed the original problem no worries but now the cracked corners have spread across the bottom 1/6th part.
Bloody Nora, I wasn't even pissed!
Ow well, live and learn.
Dire Straights on the small screen again tonight then.