30-04-2018, 10:39 PM
(This post was last modified: 30-04-2018, 11:13 PM by admin_monkey.)
Looks like only a 3 pin transistor on that circuit board.
It (the trannie) showed 8v on the 15v drill battery I used to test them, so is about right and working for a 7.2v gayogag.
I'd remove the curly cords on both and soldier in some new thicker wire that will handle the PTT drain amps better and not twist in the case.
Heat sink on the transistors would be good as well but I don't think there's much room in the case for anything but some alloy foil (wrapped length ways) around the black square part of the trannie.
I just made love to a
It (the trannie) showed 8v on the 15v drill battery I used to test them, so is about right and working for a 7.2v gayogag.
I'd remove the curly cords on both and soldier in some new thicker wire that will handle the PTT drain amps better and not twist in the case.
Heat sink on the transistors would be good as well but I don't think there's much room in the case for anything but some alloy foil (wrapped length ways) around the black square part of the trannie.
I just made love to a